FS Switche: Unterschied zwischen den Versionen

Aus d0b
Zur Navigation springenZur Suche springen
 
Zeile 87: Zeile 87:
  
 
== Produke ==
 
== Produke ==
==  S1600-48T4S ==
+
===  S1600-48T4S ===
*
+
  
 
=== S3400-48T4SP ===
 
=== S3400-48T4SP ===

Aktuelle Version vom 21. April 2020, 14:51 Uhr

Allgemein

Terminal Settings

  • Symbolrate von 1200 bis 115200 (default 9600)
  • 8 data bits
  • 1 stop bit
  • no parity
  • flow control set to Xon/Xoff

mit Screen sieht das dann so aus:

screen /dev/cu.usbserial 115200,cs8,-parenb,-cstopb,-clocal

Console

Rechte Level

Switch>                                  // 
Switch#                                  // Privileged EXEC Mode
Switch(config)#                          // Global Configuration Mode

quit/exit                                // Aktuelles Rechtelevel bzw. Switch verlassen


"enable" -> "configure terminal" 
  |                \-------------------- switch to "Global Configuration Mode"
  |                
   \------------------------------------ switch to "Privileged EXEC Mode"

Show Configuration

show management ip address                // Default:  192.168.1.10/24
show management ipv6 address
show interface status


Basic Configuration

hostname name                                                               // Hostnamen setzen                         

management ip address A.B.C.D/M |A.B.C.D mask) (gateway A.B.C.D)            // IPv4-Adresse für Netzwerk Management setzen
management ip address 192.168.1.10/24                                       // Beispoel ohne GW
management ipv6 address (X:X::X:X/M | X:X::X:X mask) (gateway X:X::X:X)     // IPv6-Adresse für Netzwerk Management setzen

enable password

Basic VLAN

conf t
interface vlan 1
no ip address dhcp                                // DHCP CLient abschalten
ip address 192.168.23.23 255.255.255.0
copy running-config startup-config                // config speichern


LACP Dynamic

Eingaben im Global Configuration Mode "(config)#"

lacp system-priority 2000 
port-channel dynamic-load-balance enable 
interface eth-0-1
  no shutdown
  channel-group 1 mode active
  exit
interface eth-0-2
  no shutdown
  channel-group 1 mode active
  exit  
interface agg 1  
  jumboframe enable                               // MTU anpassen
  exit

copy running-config startup-config                // config speichern




show channel-group summary                        // config prüfen
show interface agg 1
show lacp {counters | internal | neighbor | sys-id}  

Produke

S1600-48T4S

S3400-48T4SP

  • Fiberstore Co., Limited Internetwork Operating System Software Version 2.2.0J Build 68107,

Abweichende CLI Befehle!

config    // Global Configuration Mode
write     // Speichern

S5800-8TF12S


Default Login

  • User: admin
  • Password: admin