FS Switche: Unterschied zwischen den Versionen
Aus d0b
Zur Navigation springenZur Suche springenSysd0b (Diskussion | Beiträge) |
Sysd0b (Diskussion | Beiträge) |
||
Zeile 30: | Zeile 30: | ||
'''Show Configuration''' | '''Show Configuration''' | ||
<pre> | <pre> | ||
− | show management ip address | + | show management ip address // Default: 192.168.1.10/24 |
show management ipv6 address | show management ipv6 address | ||
show interface status | show interface status | ||
Zeile 52: | Zeile 52: | ||
conf t | conf t | ||
interface vlan 1 | interface vlan 1 | ||
+ | no ip address dhcp // DHCP CLient abschalten | ||
ip address 192.168.23.23 255.255.255.0 | ip address 192.168.23.23 255.255.255.0 | ||
copy running-config startup-config // config speichern | copy running-config startup-config // config speichern |
Version vom 4. September 2019, 17:50 Uhr
Inhaltsverzeichnis
Allgemein
Terminal Settings
- Symbolrate von 1200 bis 115200 (default 9600)
- 8 data bits
- 1 stop bit
- no parity
- flow control set to Xon/Xoff
mit Screen sieht das dann so aus:
screen /dev/cu.usbserial 115200,cs8,-parenb,-cstopb,-clocal
Console
Rechte Level
Switch> // Switch# // Privileged EXEC Mode Switch(config)# // Global Configuration Mode quit/exit // Aktuelles Rechtelevel bzw. Switch verlassen "enable" -> "configure terminal" | \-------------------- switch to "Global Configuration Mode" | \------------------------------------ switch to "Privileged EXEC Mode"
Show Configuration
show management ip address // Default: 192.168.1.10/24 show management ipv6 address show interface status
Basic Configuration
hostname name // Hostnamen setzen management ip address A.B.C.D/M |A.B.C.D mask) (gateway A.B.C.D) // IPv4-Adresse für Netzwerk Management setzen management ip address 192.168.1.10/24 // Beispoel ohne GW management ipv6 address (X:X::X:X/M | X:X::X:X mask) (gateway X:X::X:X) // IPv6-Adresse für Netzwerk Management setzen enable password
Basic VLAN
conf t interface vlan 1 no ip address dhcp // DHCP CLient abschalten ip address 192.168.23.23 255.255.255.0 copy running-config startup-config // config speichern
LACP Dynamic
Eingaben im Global Configuration Mode "(config)#"
lacp system-priority 2000 port-channel dynamic-load-balance enable interface eth-0-1 no shutdown channel-group 1 mode active exit interface eth-0-2 no shutdown channel-group 1 mode active exit interface agg 1 jumboframe enable // MTU anpassen exit copy running-config startup-config // config speichern show channel-group summary // config prüfen show interface agg 1 show lacp {counters | internal | neighbor | sys-id}