FS Switche: Unterschied zwischen den Versionen
Aus d0b
Zur Navigation springenZur Suche springenSysd0b (Diskussion | Beiträge) K (→Console) |
Sysd0b (Diskussion | Beiträge) |
||
Zeile 69: | Zeile 69: | ||
channel-group 1 mode active | channel-group 1 mode active | ||
exit | exit | ||
+ | interface agg 1 | ||
+ | jumboframe enable // MTU anpassen | ||
+ | exit | ||
+ | |||
copy running-config startup-config // config speichern | copy running-config startup-config // config speichern | ||
+ | |||
+ | |||
+ | |||
show channel-group summary // config prüfen | show channel-group summary // config prüfen |
Version vom 17. August 2019, 16:51 Uhr
Inhaltsverzeichnis
Allgemein
Terminal Settings
- Symbolrate von 1200 bis 115200 (default 9600)
- 8 data bits
- 1 stop bit
- no parity
- flow control set to Xon/Xoff
mit Screen dieht das dann so aus: HP5130 (JG933A)
screen /dev/cu.usbserial 115200,cs8,-parenb,-cstopb,-clocal
Abweichende Switche
HP1920-24g-poe (JG928A)
screen /dev/cu.usbserial 38400,cs8,-parenb,-cstopb,-clocal
Console
Rechte Level
Switch> // Switch# // Privileged EXEC Mode Switch(config)# // Global Configuration Mode quit/exit // Aktuellen Mode bzw. Switch verlassen "enable" -> "configure terminal" | \-------------------- switch to "Global Configuration Mode" | \------------------------------------ switch to "Privileged EXEC Mode"
Show Configuration
show management ip address show management ipv6 address
Basic Configuration
hostname name // Hostnamen setzen management ip address A.B.C.D/M |A.B.C.D mask) (gateway A.B.C.D) // IPv4-Adresse für Netzwerk Management setzen management ip address 192.168.1.10/24 // Beispoel ohne GW management ipv6 address (X:X::X:X/M | X:X::X:X mask) (gateway X:X::X:X) // IPv6-Adresse für Netzwerk Management setzen enable password
LACP Dynamic
Eingaben im Global Configuration Mode
lacp system-priority 2000 port-channel dynamic-load-balance enable interface eth-0-1 no shutdown channel-group 1 mode active exit interface eth-0-2 no shutdown channel-group 1 mode active exit interface agg 1 jumboframe enable // MTU anpassen exit copy running-config startup-config // config speichern show channel-group summary // config prüfen show interface agg 1 show lacp neighbor